Banner
Home > Industry > Content
Installation and maintenance of 3D laser 4 wheel alignment
- 2022-03-18-

1. When installing the locator of the 3D laser 4-wheel alignment instrument, the ground wire must be connected to the expansion bolt (the ground wire should be inserted into the ground). Otherwise, the static electricity of the computer will interfere with the data and even damage the camera.

2. Keep the four target plates clean and dry, without water or oil. Otherwise, the target plates will have to be replaced.

3. Protect the cameras on both sides of the beam to prevent collision. Keep the lenses clean and clean them regularly.

4. The positioning computer cannot access the Internet, and cannot be randomly pasted into the USB disk to prevent virus infection.

5. Do not paste and install anti-virus software to prevent the location software from being deleted.

3D laser 4 wheel alignment installation

1. When installing the computer, be sure to install a ground wire (the ground wire should penetrate the ground and cannot be connected to the expansion bolt). Otherwise, the static electricity in the computer will interfere with the data and even damage the camera.

2. When installing the column, the column must be located 1.7m in front of the middle of the elevator. The range is 1.5 to 2 meters.

3. When installing the beam, the cameras on both sides cannot be hoisted, and the cameras on both sides cannot collide with each other to prevent interference with the stability of the cameras.

4. When installing the camera line of the 3D laser 4 wheel alignment instrument, you must pay attention to combine the light beam along the camera line with 1 and 2, and make sure to put it on the same computer USB port column, and combine line 1 with line 2.

3D激光四轮定位仪