3D Laser 4 Wheel AlignmentInstallation
1. When installing the computer, you must install a ground wire (the ground wire should pierce the ground and cannot be connected to the expansion screw). Otherwise, the static electricity of the computer will affect the data and even damage the camera.
2. When installing the column, the column must be located 1.7m in front of the middle of the hoist. The range is 1.5 to 2 meters.
3. When installing the beam, the cameras at both ends must not be hoisted, and the cameras at both ends must not collide with each other to avoid affecting the stability of the cameras.
4. When installing the camera line, be sure to connect the light beam along the camera line with 1 and 2. Be sure to place them on the same computer USB interface column and connect line 1 and line 2 together.
Maintenance of 3D laser 4 wheel alignment

1. When installing the locator, the ground wire must be connected to the expansion screw (the ground wire should be inserted into the ground). Otherwise, the static electricity of the computer will affect the data and even damage the camera.
2. Keep the 4 target plates clean and dry, do not let water or oil in. Otherwise, the target plates can only be replaced.
3. Protect the cameras at both ends of the beam to avoid collision. Keep the lenses clean and wipe them regularly.
4. The positioning computer cannot access the Internet, and cannot randomly paste or insert a USB drive to avoid virus infection.
5. Do not paste and install anti-virus software to avoid deleting the positioning software.