Banner
Home > News > Content
3D laser 4 wheel alignment installation and maintenance matters
- 2021-08-03-

Maintenance and precautions of 3D laser 4 wheel alignment:

1. When installing the locator, you must connect the ground wire (the ground wire must penetrate the ground and cannot be connected to the expansion screw. If conditions do not allow, you can connect it to a water pipe or other conductive object), otherwise the static electricity on the computer will affect the data and even damage the camera.

2. Keep the four target boards clean and dry, and avoid water or oil ingress, otherwise the target boards can only be replaced.

3. Protect the cameras at both ends of the beam to avoid bumps. Keep the lens clean and wipe it regularly.

4. The positioning computer cannot be used to surf the Internet, and USB flash drives cannot be inserted randomly to avoid virus infection. 5. Anti-virus software cannot be installed randomly to avoid deleting the positioning software.

When installing the 3D laser 4-wheel alignment instrument, pay attention to the following points:

1. When installing the computer, you must install a ground wire (the ground wire must penetrate the ground and cannot be connected to the expansion screw. If conditions do not allow, you can connect it to a water pipe or other conductive objects), otherwise the static electricity on the computer will affect the data and even damage the camera.

2. When installing the column, the column must be installed 1.7 meters in front of the center of the lift. The range is 1.5 meters to 2 meters.

3. When installing the beam, do not lift the cameras at both ends, and do not bump the cameras at both ends to avoid affecting the stability of the cameras.

4. When installing the camera line, be sure to pay attention to the two camera lines 1 and 2 coming down from the beam. They must be in the same column on the computer USB port, with line 1 on top and line 2 on the bottom.