News

1. The first step is to open the corner detection interface. 2. The second step is to click the start detection button on the interface. 3. The third step is to start the operation, and the operation

1. The first step is to open the corner detection interface. 2. The second step is to click the start detection button on the interface. 3. The third step is to start the operation, and the operation

After the alignment is completed, the data will be tested. The interface will show the prompt message "Testing". At this time, you can operate the "Pause Test" and "Continue Test" buttons on the inter

The manual operation of 4-wheel alignment is to manually test the operating parts of the equipment. The following figure (6-1) is the manual operation interface:

The wheelbase adjustment uses a high-precision servo motor for positioning, and the wheelbase can be flexibly adjusted within the specified stroke. The wheelbase is adjusted by the cylinder fixed-poin

The tire pressure of the inspected vehicle should meet the national standard value, and the metal, stone or mud and sand mixed in the tire should be removed in advance to extend the service life of th

Place the equipment on the calibration screen and place the calibration device on the front wheel detection part of the equipment. Start the roller motor and the detection mechanism. After the three r

Typical test process (I) Test preparation phase (I) Ø Test bench original position (2) Ø Vehicle identification (via barcode\/vehicle button\/MFT), download test parameters (3) ● Vehicle enters (4) Ø

A 41-inch TV monitor is used to display the values ​​of toe, camber, caster and steering wheel angle, the VIN code of the vehicle to be inspected, and the vehicle entry and exit information. It is ins