In the hot summer, many drivers like to install 3D4 wheel alignment, but do you know how to use 3D4 wheel alignment to perform maintenance in the summer? The following editor will analyze it for everyone.

1. Electrical safety of mechanical equipment

① In summer, when the power consumption is high, there are many high-power equipment in the car repair shop. In order to better ensure that customers can operate normally, the editor recommends that customers who use 3D4 wheel alignment should be equipped with a small adjustable voltage stabilized power supply to ensure the reliability of the work, which can reduce and ensure the loss of electronic components of mechanical equipment.

② If there is a frequent power outage, in order to consider the safety of data, it is best to configure the computer with a UPS power supply.

2. Anti-fouling and waterproof treatment of important electronic components of mechanical equipment

①Since the 3D4 wheel alignment machine is composed of high-precision electronic components, moisture and water resistance are particularly important.

②With the regularity of regular rainfall, especially in southern my country, please make preparations for moisture and water prevention; in addition, mechanical equipment should avoid car wash stations as much as possible.

③In addition, the accumulation of dust inside the computer may also cause problems such as slow computer response, inability to start up, black screen, etc. Therefore, in auto repair shops, auto parts markets, and shops along the street, try to do a good job of anti-fouling treatment on the above structural parts, and close the main chassis door frame immediately after the use of accurate positioning mechanical equipment.

3. Common problems in the maintenance of 3D target disk and bracket

①After use, immediately put the target disk back into the main chassis and clean it with a soft dry cloth to avoid surface scratches.

②Avoid direct sunlight and place in a cool place. If the top edge of the bracket is severely damaged, replace it as much as possible to avoid scratching the wheel hub.

③ Grease the ball screw and the slide rod of the bracket regularly to ensure their coordination. The bracket must be handled with care. If it is not in use, it must be placed on the bracket for maintenance to avoid damage that may cause inaccurate measurement accuracy and extend the service life of the mechanical equipment.